There is really only one rule to follow when it comes to removing and attaching your hair replacement system and that is proper prior preparation.
When removing and attaching your hair replacement system, first of all you need to remove your hair system for clean up and re-attachment. You may damage your hair system if you don’t take proper care at the removal stage. Firstly apply an adhesive remover such as Lace Release directly to the scalp where the hair system is attached starting from the back of the unit. Removing back to front is essential to protect the front hairline so peel up from the back and gradually lift forwards. Continue to peel forwards spraying or dabbing with your adhesive remover as you go. Once the hair system is removed you can start to clean your scalp and hair system separately.
Before attaching your hair system you will need to make sure you have completely removed any of the adhesive residue from the lace or poly on the base of your system. Use a good solvent such as C22, Ghost Buster or Ultra Safe by spraying directly onto the base of your hair system and leaving it to penetrate – depending on the level of residue this can be anything from 15 minutes to an hour or even overnight.
Once the solvent has penetrated, start to remove the residue with a paper towel, a microfibre towel, a nail brush or even a spoon, whichever you prefer. It is imperative that once all the adhesive residue has been removed, you remove any of the oily solvent from the base of the hair system. You can do this by using a grease cutting washing up liquid – original Fairy Liquid is a good option.
You are now ready to shampoo and condition your hair system using a properly formulated shampoo and conditioner such as Walker Tape Bond Breaker or Professional Hair Labs Pro Series, making sure you apply the shampoo and conditioner base side up to ensure you do not push the hair back through the system.
Your lifestyle and hair wearing habits will largely dictate which process you use to remove and attach your hair system, but whether you take your system off daily or after several weeks, the key to a successful and long lasting bond is scalp preparation.
Scalp Preparation:
ONE
Remove all adhesive residue: Use a good solvent such as C22, Ghost Buster, Ultra Safe or the S3 Sensitive Skin Solvent if you have sensitive skin to remove ALL traces of the adhesive residue. You can use a paper towel with the solvent and rub vigorously until your scalp is clear of any residue build up.
TWO
Wash the scalp thoroughly: Shower and wash your hair using an exfoliating Scalp Scrub with a good shampoo. Finish off using a good sulphate free shampoo. Repeat as often as necessary to remove ALL traces of residue.
THREE
Dry your head: Fully dry your head using a towel and and/or a hair dryer. This would be a good time to shave any hair or stubble from the bonding area. At this point you can also apply a medical grade alcohol to ensure the scalp area is pristine clean.
FOUR
Apply a water proof sealant: Use a scalp protector on the bonding area to protect your skin as well as encouraging adhesion, ensuring the sealant has fully dried before attaching your hair system.
Youll find more helpful advice and tips on which adhesives and tapes to use to attach your hair system here:
HAIR TAPES ADVICE
HAIR ADHESIVES ADVICE
The more care you take with your hair system, the longer it will last, the better it will look, and the greater you will feel!
You can buy any of the products you need for all of these procedures from our online hair care shop.